Step 1: Clean the flooring
As common flooring are made of asphalt, concrete, it is important for flooring to keep solid, and leveled, dry and clean as the same time free of cracks.
Second place in the rubber roll on the ground
In term of glue the rubber mat we can two options one is use Rubber Gym Mat Adhesive
Or we can use the double tape which you can buy from Home Depot
Step 2: Roll out the rubber
Organize the rolls within the room according to your desired appearance after a complete installation. Use a measurement to measure the distance that you need for the rubber roll. Make some cuts in order to let the rubber roll fit into the room. Straight Edge and a utility Knife is a great tool to cut the rubber. (Tips make sure you have a lots of sharp blade, as rubber mat need sharp blade to cut.)After organize the rolls within the room according to your desired appearance following a thorough installation overhaul.er you finish the cutting and make the rolls laid out the way that you want, roll back the roll to one end of the room.
Step 3: Apply glue
If employing Rubber Gym Mat Adhesive, evenly apply the glue over the designated installation area.
In the case of double tape, begin affixing it to the floor in the prepared installation area.
Step 4: Install rubber
Place the rubber roll onto the glue, being attentive to promptly remove any glue spills on the floor. Swiftly clean the areas affected by glue as soon as possible.
Step 5: Pressure roller
Upon completing the gluing process of the rubber onto the surface, it is imperative, before the glue fully solidifies, to uniformly exert pressure using a substantial carpet roller. This step aims to eliminate any air bubbles underneath the rubber, ensuring a secure adherence to the glue.
It is crucial to note that after installing the rubber, refrain from walking on it until the glue has thoroughly hardened.